The happiest day of planting is coming soon. That’s my first grow. I have never experienced before this time. I did it 😎. i made flushing at 26.1.2023. Chopping is coming next week.

Day 91: Trimmed and jarred 79.1 grams (partial harvest) Day 97: Trimmed and jarred 35grams (final harvest) Total: 114.10 grams / 4.025 ounces I must have smoked at least 5 grams that was not included in my final count :)

Growin

2/10: I watered today with about 3/4 gallon each, plus cal-mag, signal, bembe, armor si, a little open sesame, and their final dose of endoboost. The shorter one is budding up quickly now. 2/11: Wife home sick today....postponing construction project to raise the lights. 2/12: Today, I tackled the project to raise my ceiling another foot. In addition to that project, I installed and hooked up my new AC Infinity 6" intake fan. It's pulling in fresh air from the soffit vent on the eave of the attic, and currently feeding the garden with 46f fresh air. I'm able to easily maintain daytime temps in the lower 70f's now. I am able to drive the nighttime temps as low as I want. The only issue is that the outdoor RH varies quite a bit, so I ordered a 30-pint dehumidifier to put in the top of the closet. I sprayed everybody with boomboom spray to try and mitigate the light burn damage that is likely to ensue. 2/13: The taller one is still stretching a little bit, but the 2-footer is just budding up. 2/14: I fed them today with about 3/4 gallon each including grow big, big bloom, tiger bloom, cal-mag, signal, bembe, humic acid, and I switched over from Open Sesame to Beastie Bloomz. Raised the lights another couple of inches. I did some training on them and defo'd a little bit. 2/15: Installed the new dehumidifier and rigged the continuous drain on it...works great. 2/16: I rotated the edge plants and removed some old leaves. I added another 22w 3000k 4' bar light under the canopy. 2/17: I rearranged the garden and defoliated a little bit. That's it for week 8-

the girl is blooming :) she won't be big, but I think she's beautiful :)

We had no humidity for 3 days, but everything continues normally. We don't stop.💚

Die topf pflanze wurde von 4L in einen 10 L stoff topf umgepflanzt.

Hi! Just harvest both plants, left them with all their leaves and whole main branch intact. Just removed the light panels and hanged them on the same tent. I’m using some cardboard to cover the recently watered soil, blumats are still running to support the life on the soil through the next amendment and new plants that will come shortly (after the drying period finishes, about 2 weeks for a slow drying process). That’s it :)

Vegetation: To keep temperature and moisture on optimal levels at around 23°C / 65% I'm using two mechanical timers. - 24/7 on: Fans and water pumps (+Ventilation after 3.11.) - Timer 1: Lights and Humidifier 18h on / 6h off - Timer 2 (BROKEN 3.11.): Ventilation 18h (15min on / 15min off) / 6h off NOTES: Everything looks good and the roots have appeared from almost every (11/13) rock-wool cube. From now on I'll mostly water the plants from bottom by adding the wanted amount of nutrient solution on a plate, and then placing the plant on top of for ~15seconds This week I'm also starting to prepare the hydroponic systems (2x NFT-GT90, and 1x EBB-flow I think) and stronger nutrient solution since my plants are becoming ready to be transferred. Spreader-mat is the base of my plants when I have transferred them in to the hydroponic systems. DO NOT place more than one layer of the spreader-mat as it is not meant to be used like that! As you're cutting the mat for NFT's, be aware to have some extra for your peace to reach nutrient solution below the tray. That way you won't get noise from water dropping when systems are turned on. Day 15 (1.11.) Day 16 (2.11.) First watering with a bit stronger nutrient-solution (~ EC 0,6 / pH 5,9) than before, starting with 50ml/plant and watering once from above. Slowly increasing EC to 0,8. I cleaned and assembled 2 out of 3 hydroponic-systems which I'm going to use. I'll do the same also to the last system, but it currently has my plants on top of it so I'm going to do it later. I want to make sure that my plants have built healthy and big enough root system before transplanting to hydroponics. I'm waiting for the rock-wool cubes to be bursting of roots so they won't drown on their first day in hydro. Also, as the plants are bigger before the transplant, I'm able to fill my nutrient-solution tanks full with correct strength nutrient-solution for Mid-Vegetation from the start, therefore no need for that much adjusting later on. Day 17 (3.11.) I noticed my other timer which controls the lights had stopped working... The lights were on when they shouldn't have been, I noticed it an hour after they were supposed to turn off. I think I caught up to it early, but it may have been on for maximum of 2 days straight. No worries there since on vegetation-phase the plants don't necessarily need any sleep (Even though you should avoid quick changes like that!). Roots have appeared from the bottom of every cube and plants are looking pretty healthy. I think they are almost ready for hydroponics. Day 18 (4.11.) Few plants are showing symptoms of nutrient deficiences or some sort of sickness, not certain what exactly. I'll be keeping an eye on it. I'll be transferring in to hydroponic systems in maybe a week, so I don't want to stress my plants more than what's necessary. Increased my solution strength to 0,9 EC with a bit more Cal-Mag than before, and watered the plants for 50-150ml each plant depending on weight and size. I'll be slowly increasing the strength by around 50% during upcoming week. Thanks for tips! Day 19 (5.11.) Day 20 (6.11.) Plants are recovering well from deficiences and I just transferred all of them to hydroponics. I don't have the water pumps on for 24/7 just yet, at this point I water them a couple times a day by keeping the pumps on for somewhere around 15min at a time. Lights are now set to 60% and I also added a tower fan to circulate the air and shake the plants. Day 21 (7.11.) Lights are now set to 70% since the Led's and plants are spreaded wider in the tent than before. Distance to plants stays the same at 75cm.

Absolutely no problems 30.3.25 Amnesia lemon haze 74cm GG4 82 GG4 82 Amnesia lemon haze 888 Og kush 50 Iced peach 101 In house genetic mix 87 Black cherry punch 98 Gmo cookies 75cm Ppfd up to 960

Week 16 Everybody is on Flower! End of August: daylight 13h20: 7h20/20h40. Day temperature max: 26°C - Night temperature : 17°C Sunny weather - 2/3 rainy days in 2 weeks Enriched the soil with seaweed powder and bat guano. Continue to add flowering nutrients: Grower Master I added some Calmag one time. Watering 2L/plant every 3 days (2 days would be better) With humidity growing and the relatives hot temperatures: the predators are attacking plants. Everything appears so fast: Aphids, caterpillars, leaf miner flies. Did a general defoliation before spray my mixture Garlic + laurel (12cl Garlic juice + 5cl laurel infusion + 1L distilled water: beware PH!!). I sprinkled diatomaceous earth on top of soil to protect and minimize the infestation. Brake Pad Breath: still deep green and bushy. Flowering since 4 weeks. The most advanced, pretty good flowers with long pistils are growing. Spared until now: the plant is victim of Aphids, miner leaf flies and caterpillars in a « reasonable way »….try to eradicate the problem without shocking the plant at this stage. Flash Back#2: around 2 weeks flowering, stretched a few centimeters more, well developed plants with lot of blooming sites. Relatively spared by pests, just some aphids. GMO X Zombie Kush: some difficulties to recover….just engaged the flowering process, not to bad if she resist to the second pest’s wave. Royal Moby: uncertain destiny….recovering good, sativa style: 155cm, just starting the flowering stage…super late! Harvested a pretty auto flower: White Russian by Serious Seeds. Well developed plant, a little bit long to be ready but resinous and meaty buds.

Week 10, Week 10 has been fun. The buds are becoming denser and starting to almost look like a finished product. I am planning on harvesting the plant the first week of next month, so three weeks or so and counting! I am adjusting the tie downs twice a week trying to get the buds as much sunlight as possible. I am watering every 3 days with 6.0 ph water. I have been putting a teaspoon of FloraNova in the water with a tablespoon of molasses mixed in but it appears she received a little nutrient burn. I'm not to worried about it because I wanted to make sure the flower sites received enough nutrients to make some dense dank buds. It isn't a huge burn but a little. As a result I started mixing only half a teaspoon of FloraNova in the water to make sure any future burn doesn't happen. I am excited about the plant, she is starting to look like a thiccy ha I am probably going to starting flushing in three weeks. Let me know if you have any questions/concerns/comments. Happy growing Growmies 🙌

She’s getting closer to chop! I would say about another 1.5weeks max on this girl.. buds are getting fat and frosty and she is full of blueberry terps! I’ve been giving her a diastatic malted barley tea with molasses and bokashi bran to help boost nutrient cycling and she’s been responding very well to that! Was hoping for more anthocyanins but maybe they will appear closer to harvest.

During my previous grow, I harvested and made some bubble hash. Afterward, I dropped the used, wet buds onto this coco, and it seems some seeds sprouted from the leftover material. I’m not even sure if they’re photoperiod or autoflower, but hey—let's roll with it! Both my pH meter and PPM meter are broken. I have no idea why they keep breaking so often. They’re ADWA meters, and while you can replace the reading elements, the replacements cost half the price of a new meter. It’s frustrating, and I really don’t want to keep buying them every time I start a new grow

Grow went well. Spider farmer produces again the se5000. One day they myt sponsor me beofre someone else does. Dyno myco somw gd stuff chek out ppl.

Exploding with growth happy looking so far any thoughts guys

To start I would like, give big thanks to Royal Queen Seeds ❤️❤️ and @James , ❤️❤️ to try their products one more time #RQSLOVER, also to @marshydrococo2 and Mars Hydro for the FC 3000 and the fan filter kit ❤️❤️ And another thanks for the GD community, for likes, comments, follows. This 2nd F1 strain run was great, Easy and beautiful, very similar with Epsilon 💚 Flower/herbal smeel 👨‍🌾🌲🌲 ⚖️ Wet yield 262g

VIPARSPECTRA!!!!! Sex Shooter!!!!! Emergence is here, lets GOOOOO!

Another week done applying some More training Put the Ionbeam U4 inside the tent watch the unboxing video and setup! https://www.youtube.com/watch?v=B6cT9c1UfSo