YESTERDAY BAD THINGH HAPPENED. I realized that the PH meter was broken and the PH res were very much lower than what I guessed!! The roots was immerged from many days in a really acid solution. So I completely changed the res and eliminated all the rotten branches (that was many). I hope my girl will survive to this bad stress. Finger crossed New Res: 11/06 EC: 1,24 PH: 5,97 12/06 EC: 1447 PH: 6,38 13/06 EC: 1335 PH: 6,16 14/06 From now on, I will give only GHE Ripen (Final Part) to her. Planning to change the res on Friday, for the last two weeks of ripening with only ripen and bio bloom, adjusting the PH whenever above 6 to give some relief to her after 13 days in an acid solution. she seems to recover now (fingers crossed) Today I added 1L with 5ml of ripen and 4 drops of Bio Bloom and PH+ to raise up until 6,4. Now the res is: EC: 1403 PH: 6,45 15/06 The girl is survived and this is the only news I would like to hear! Now the PH is stable and the acid solution should be finally gone. From now on I will dispense only RIPEN: added 1l with 4 ml of ripen. On Friday night I will add florakleen for 24 hours and then on Saturday night new res with only ripen and Bio bloom before the final flush. Today situation is: EC: 1494 PH: 6,25 👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍 Lesson Learned: CHANGE THE SOLUTION EVERY 10 DAYS AT MOST (BETTER EVERY WEEK) BEFORE TO CHANGE THE SOLUTION LET FLASH CLEAN RUNS FOR A COUPLE OF HOURS IN THE OLD SOLUTION PAY ATTENTION WHEN THE FLOWERING STOPS AND THE RIPENING STARTS 👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍 16/06 Finally the PH restarts raising. Maybe this means the roots have finished to drain the previous acid res. I'm happy of that ! The EC is still raising, so I put less Ripen in the new added water. She's drinking a lot. I added 4 L of water today EC: 1655 PH: 6,26 17/06 Added 1L with only Ripen and Hydroguard Ready to change the solution the next week EC: 1684 PH: 6,17

Added the first screen into the tent. Decided to kick Big Mumma out because she just wasn't growing any taller and the other plants were really over growing her. For the new setup I used kitty litter trays and mesh to sit the plants on - each plant gets its own tray so I can track runoff EC individually and I cut little flaps in the mesh so I can wet vac the runoff. With this setup I shouldn't need to move the plants out of the tent until harvest. For the scrog I just tied some builders rope around the poles of the tent and tied the trellis netting off with training wire. I've been manipulating the growth just to try and fill out the whole screen, I also gave them a good haircut because I plan on flipping them soon, don't want them to outgrow the tent.

No joke, the small plant last week blew up. It grew almost 10 inches in a single week! I had to put the Vulcan pinch on this skinny beast! I know it’s taboo to let train a plant in flower but she was forcing my light up.

Última semana de floración de estas candy caramelo y es que vaya flores son como rocas muy compactas kio, de lo mejor que e visto también en mucho tiempo fumetillas. Plantas pequeñas con un buen porte y un buen grosor de tallo, son bastante rápidas a la hora de florecer, os aseguro que las aguantaba una semana más pero por temas de virus y tal decido cortarlas ya que también están bien bastante contento en verdad con esta varieddd. Mantuve ph hasta el final controlando humedad y temperatura pocas veces desvarío el asunto. Muy muy contento zambeza hizo un fast bastante curiosa con olores dulces .

Did some more defoliation for more light penetration.

Hear we go test growing the new batch of seeds!! So far nice split going on! 7 out of 10 split and planted!! 7 heads popping up!

massive growth in this girl. i decided to flip them both cuz they are in a 2x2. trying to get 12 tops. 6.3 ph 1800 ppm run off. the one girl goy reckt by knats so her roots got stunted. haven't decide what to do. toped her and she grew strange. gonna bump up the lights a bit maybe she streached out to much. topped one last time in the 3 gal. cal mag and silica only for now.

Week 3 begins for DS and MD ladies. All four are developing nice bud sites, but the plants have not stretched as much as I was expecting they would by now. Thank you to Kaoritracy from Mars-Hydro for the TSW2000 light, I am very happy with it's performance. Thanks for stopping by growfessors 👽🌳💚

Day 23 stacking and packing!!! She’s getting stinky and dank...... got a slight nutrients burn on a couple remo nutrients plants been flushing to get the EC down lots of growth lots of trichome

11.08.2024 sorry have loosing lot of photo as the timelaps cam sd card get corrupted.😒 from the 12 initial cut 8 have been keep, 2 didnt make it an the 2 other have been discard.

10 September Harvest - see pictures. While some growers leave the plant whole when they cut, I do not. It is a personal preference and situational convenience if your a home grower. I chose to cut large, long branches, and remove any whole water leaves, as long as it doesn’t interfere with the bud formation. I don’t trim yet. This is done for a few of reasons: 1) It’s my last good close-up look at her until another 5 days or more, 2) I don’t want wet leaves drying on my buds if I can help it, and 3) I occasionally like being able to shine a small LED flashlight on the flowers while its drying. Mold is our greatest problem as growers, it can destroy a beautiful grow right up until the end process. Then I hang it in a dark closet, provide circulation and ventilation. Light and heat, anything above 80 degrees F, will start a break down in cannabinoids during the dry, it is ideal to stay away from both. I’m fortunate that a humidity level of 50- 55% and temperature of 65-70 degrees F is fairly consistent and easy to maintain. Anything below 60 degree F will prevent the adequate drying out of chlorophyll. Almost all my flower routinely take 5-7 days, some a little longer, to properly dry out. 15 September Trim - see pictures. First you’ll notice the buds have shrunk up to half their original size. This is just a fact that we growers have to deal with. Due to evaporation without uptake of water, it takes about 3 days for the chlorophyll to dry up, then slowly go through a chemical change. Along with the leaves, cannabinoids also begin a chemical change after 3 days called decarboxylation. A slow process where the THC level increases while curing. You want the leaf to be dry so they can be hand trimmed easily, but you do not want that bud so dry that it starts to fall apart in your hand. Try to handle carefully by the main stem to avoid touching the bud all together. A lot of these cut leaves will be covered with trichomes, good for making oils, or other products, it’s an option worth looking into keeping it. After trimming, I do separate a few premium flowers for my first smoq. Then loosely fill wide mouth quart mason jars with about 1 oz/28 gr of product per jar. I seal the lids for a few hours to determine what relative humidity they are at, see hygrometer pic, before making a decision to put in a 62% humidity control pack of my choice or to wait, then place in secure in a cool dark place with stable humidity and temperature. It is very important to then observe/burp or exchange the air as needed, up to several times a day, until 62% rh is achieved. Once your close to to your mark, put in your desired RH level control terpene shield. If you have a problem getting there: 1) it has dried out too much, no real solution, try to put several large cut stems left over from harvest into the jars with the buds to try and increase humidty, 2) it has not dried out enough, in this case no problem, just remove and dry out a little more. This is also a personal choice, some people like it drier in the 50% plus range. Whatever you do, research and preserve. At that time burping is no longer required. Cannabis will reach its peak potency potential at about 40 or so days into the cure. The finished product should be a perfect grind when cured correctly without clogging up your grinder, this could take a month. Now that I’ve said that, I’m sure someone has grown something that they have not been able to grind. It can remain in this state for an easy 6 months with little change, locking in all the terpenes and potencies. All you need to do is occasionally check the product to ensure there are no molds. If your grow/harvest/cure techniques are good this should not be an issue. It would not be uncommon to find many cannabis strains will last, with small degradable change, for up to one year after being stored this way. Using an airtight glass container, controlled relative humidity, maintained low temperature, and kept in darkness will equal maximum shelf life. Always avoid direct sunlight and temperatures above 80 degrees F. The reasons I’ve ultimately chosen Deep Water Culture as a grow medium. Each has their own pros and cons indeed. I found the most efficient, less maintenance and ideal solution for my situation was DWC. Burdens to overcome depend on size up set-up; initial equipment cost, size of containers, ph monitors, air pumps, type of water to use-reverse osmosis, RO cost/set-up/maintenance, ways to transfer/change water and nutrients, what nutrients to use and schedules, takes several grows to learn and understand, a 1 year learning curv, easy to nutrient burn. The Benefits of growing in water; no dirt, no bugs, no diseases, rare nutrient deficiencies/toxicities, steady and rapid growth that enables the plant to reach its genetic potential. After harvest, there is about a 1 hour equipment cleanup, sterilization and turn around process before replanting. Cannabis will perform in so many different ways and mediums, no one way is the best and the best way is the one you are using, right. Chose what works for you in the long run. There will always be an initial cost in set-up. My advice if one were in need to cut corners, I would not recommend cheap lights. This single factor is the most critical, afford for the best. The notion that organic and water has a different taste, flavor and potency effect is absolutely debatable. The more we learn the better we grow and experience is always the best teacher. This is what works for me and my methods of growing in general from beginning to end. A BIG “Thank You” to everyone who stopped by to take a look. My next diary will start at the beginning of October 2023 with a Forbidden Runtz Auto. There will be minor differences during the grow. I enjoy Auto strains simply by what can be achieved in a short time. No matter the strain they will unveil one thing in common, the demand for attention. Many times over it is the anecdotal gardener that surmount plant scientist. Last should I mention, do not forget to stop and enjoy the fruits of your labour...

After deciding to start this new growing journey, I chose to germinate a Banana Purple Punch seed from Fast Buds. This particular strain caught my attention with its unique characteristics, and I couldn't resist giving it a try. I began by using a hydrogen peroxide water solution to germinate the seed, which helps oxygenate the water and prevent harmful pathogens. After about 36 hours, the seed cracked open, revealing the first signs of life. With a taproot emerging, I carefully transplanted the sprouted seed into a 20L airpot, ensuring enough room for the roots to breathe and grow freely. This marks the beginning of an exciting new adventure, nurturing this intriguing strain to its full potential.🌱💚 _________________________________________________________________________________________________________________________________________________________________________________________________________________________________ One of my cannabis seedlings unfortunately didn’t survive in the pot....😭 Now, I’m trying again with two more seeds of the same strain, but I’ve changed my approach. Once they've successfully sprouted, I transfer them into coco tablets. There, they’ll remain until they’ve developed healthy roots before being moved to their final growing environment. I’m hopeful that this method will help me handle the early phase of the cannabis plants more successfully, and I’m excited to see how things turn out.💚💚

Just letting them do their sweet thang.

Hello my friends 👨‍🌾👩‍🌾, This week was better, I've removed the bottles of the #1 and #2, both look really better and happy. The #3 finally to wake up ⏰, still covered by bottle for humidity. I vaporise 2 times per day with water + rhiso @PH 6 Lamp is now 100% See you next week. And hope will be better 💪👌 Thanks community for follow, likes, comments, always a pleasure 👩‍🌾👨‍🌾❤️🌲 Mars Hydro - TS 1000 https://www.mars-hydro.com/ts-1000-led-grow-light Mars Hydro - FC3000 https://www.mars-hydro.com/fc-3000-samsung-lm301b-led-grow-light Mars Hydro - SP3000 https://www.mars-hydro.com/sp-3000-samsung-lm301b-greenhouse-led-grow-light The High Chameleon - Vannila T https://www.thehighchameleon.com/shop/vanilla-t-5

So close to ready, I probably could take her down now, but my thinking is that since this is a cbd strain, I'll leave her longer and get more of that couch lock. Flushing her so giving 0 nutrients, only phdown. She is in the garage more than she is outside because the weather is so bad, so I improved her accommodation, put her under a couple of sky100s and surrounded with some reflective material I have, bundled the buds as close as possible to get more lights concentrated.

Booming if i do say so myself :) scrpg installed on the set up which is a 120x60x150

First week of flower done and starting to see little white hairs already on the amniesa kush and the big bang. TheIncredible bulk is stretching nicely. autos are doing amazing, check out my 420 fast bud diary for that one.