Likes
Comments
Share
Растишка начала обратно зарастать листвой, появляется первый предцвет!
Likes
21
Share
@Hydronaut
Follow
A step back recently: Started a final flush (2 days in), and decided to start feeding her again - thanks to some great GD input! 250 ppm at re-start and will work my way to 500ppm? She's still rockin' along - like nothing happened. She topped out at 350 ppm without tanking PH, so she is stable here. PH is now swinging down fairly quickly last 12 hours. Drained off 1/3 of reservoir and get reservoir down to 250PPM. 5 days later, major PH swings down again. Mixed another fresh reservoir. I am using Zero Water 5 gallon system, and just realized the PPM coming out was 100, and PH at 3! If I am at 100 today, that means these filters have been shot for a while, maybe since start of my PH issue. There is also interesting information about when zero water filters reach their expectancy. They put out fishy smell and otherwise. I will be watching my filters more often and taking more notes since this ZeroWater 5 gal system is really the way to go if you are only growing a plant or two. Filters are a bit spendy but when you take time, gas, convenience etc. its a no brainer (if the water coming out is zero:) - I get about 15 gallons per filter (175ppm from tap). Day 70. It’s been about a day since new res change. Steady Eddie at 250 ppm and 6.2. I’ll let her drink the bucket down a good ways if things remain stable with a drift down. I doubt it though, 5 gallon is fine for 12” autos but at 2’ she really needed 8 gal. Time to up the R&D on the cabinet! Also checked Zero Water again and filter is now putting out 200ppm of 3.0 water. New filters installed! Hope she finishes soon, the top of her canopy slowly getting cooked over the last 10 days. 8" of light distance is too little. PPFD 2000+ at the top, but leaf temps are in the upper 70's. Gotta hit a decent DLI on these lower buds - without nuking the top nugs, right?! As the week concludes, she’s in a fresh bath, at 250ppm @ 6.0 and running stable again. New water filters installed so zero water variable removed. Last serving of half+ teaspoon of GH dry KB ripening, and will reduce ppm by 25/day until I reach 10-15%. 1-2 day flush, if at all.
Likes
6
Share
No deficiencies thus far adding some molasses each feeding 1 tbls per gal water
Likes
15
Share
Likes
3
Share
Week 7 of flower 9/20/24 Changed the nutrients on 9/23/24 to fit the ripening stage. Using FinalPart with ProBloom EC 1.3, PH 6-6.2. Checking runoff PH and EC daily (EC 1.25, PH 5.2). Using H2O2 with every watering (to help the PH stabilize at 5.5-6.5 range if there is a root problem). Plant seems happy and not showing necrosis/nutrient burn problems. Hand watering ones a day at the beginning of the light schedule.
Likes
4
Share
@Tomdm123
Follow
The nematodes worked great against the fungus gnats and i almost completely got rid of them. Starting to feed her this week. Also started with low stress training this week.
Likes
17
Share
Dear friends, I wish you a Merry Christmas and a Happy New Year! I can’t say that something more important happened to me this week than your time spent with your family)) But I’ll tell you a couple of things! Firstly, I set up a camera and recorded timelapses, enjoy)) Secondly, I started new pallets while both bushes are on the same, but will stand on different ones when they grow large. In third place this week, but the most important is automatic watering. One pump waters 2 plants with a solution at once, watering occurs evenly at 1100 ml per minute per plant. At this stage, I water the plant 4 times a day, 300 ml each. 700-800ppm. pH 5.8 is strictly observed. In fourth place is the news that I cut off the tops, after that I will try to bend them in different directions before installing the scrog mesh. Next week we will install a scrog net, a co2 tank, an automatic co2 supply system. By the way, I forgot to tell you, all growbox systems work from the application on the phone: watering, nutrient solution, fans, and we will add co2. next week. In the meantime, friends, I wish you happiness and great harvests in the new year! I love everyone!
Likes
25
Share
@Jimmy89
Follow
All coming along well, nice even canopy to say there is no net in there, buds are looking nice and fat now, smell really good, like candy, very sticky. All photos taken day 53 of flower ✌️
Likes
52
Share
Week 8 Flower Last full week of flush (plus a couple days). She was taken down on Day 58 Flower after she'd faded enough. Most of her fans had died off and been plucked. I always cut them down approx half hour before the light is due to turn on. This is so the chlorophyll production is at its minimum, giving you the best flavour and smoke. She's a stunning girl with fat juicy fruity cola's! 🍇🍓 Thanks for following and happy growing! 🐺
Likes
27
Share
@Salokin
Follow
This plant was an absolute joy to trim. This plant consisted of buds and stems only, so I am actually curious what the dry weight will be.
Likes
3
Share
She looks and smells great can't wait to smoke her.
Likes
Comments
Share
Something happened this week but i have hot no photos😅 Started germination of the Coco milk15/07 Frostbanger auto in full vegetation ,this plant Is coming through well and i did apply defoliation in the 3rd internode to help Bud structure develope Gorilla z growing Better and Better ,transplanted in the final pot 16/07 Nice temperature drop some days below 30°C,the plants did really enjoy
Likes
3
Share
Day 18: She is absolutely loving the LED. Over the past few days she's been pushing out some new leaves. I gave her the first big water of her life today with 3 cups of regular tap water. Day 20: The leaves she's pushing out are becoming nice and wide, I personally really like the shape of them. I'm so happy to finally have a decent light and grow space!
Likes
6
Share
@PoshGrow
Follow
Welcome to Auto Alaskan Purple Grow by PoshGrow! 🍀 Week #2 2020 July 30th - August 6th General Info: When planted: 2020 July 23th. Week: 2 Days: 7 - 14 Last Update Day: 2020 August 6th. Plants: 5 Alaskan Purple Auto. Equipment: Tent: MarsHydro 1mx1mx2m or 39"x39"x72". Light: HLG 260w V2 Rspec QB Kit. Exhaust: 4" 322 CFM fan + Viper Carbon Filter. Intake: 4" 100 CFM Inline Fan. Oscillating Fan: Lower: 4" Ram Fan. Upper: 16" Oscillating Ram Fan. Humidifier: Taotronics TT-AH001. Dehumidifier: Pavlit MD750. Soil: NPK soil 40% Compost, 50% Peat Moss, 10% Agroperlite. Pot: 7 gallon Fabric Pot x 5pcs. Nutriens: Fox Farm Trio. PH Correcton: Chemoform pH-Minus Granulat. PH Pen: Cheap Chinese one, I callibrate it every time I use it. Comment: