week three flower everything looks fine so far :D eight days after defoliation I water them with 1.5l every 48h the light I use was set to 80% and it hangs 80cm away from the tops both gorillas had thrown a few balls, but I removed them as soon as I saw them, I will keep watching them!

Had to put another layer of netting for support.

Mimosa Evo Clone doesn’t seem to like the new home and shows some yellowing on the tips. I assume that this might be some sort of Nitrogen toxicity but i keep a close eye on it. LST continues. Only Lemon Orange and Exotic Runtz have been topped and they will cover the most of the tent. They are going into Flowering end of this week.

Ready for harvest in 3 days.. Going for 30 hours of darkness before bringing them down. Hoping for good smoke, buds look a bit small.🌱🎋 Oh well, better luck next time, lol..🧐

26.02.2024 Clean and disinfect tanks and filters with h2o2+vinegar acid +bleach Mix new batch with 1.7ml AN connoisseur AB + Silica @ 1% H2o2 - total 30l Donne one pass off long misting 2m with diluted nutrient solution 0.7EC. Flush buckets with diluted solution PAR 350 PPFD, VPD 0,8, RH 60-62%, Temp Night-21c, Day-24/25c, Leaf temperature 22c, Light distance 75cm, CO2 650+ppm 340w@75cm distance 45s ON time 15min OFF time PT-Pressurized tank - PH- 5.9 , EC -1.05, Temp-21c NT-Nutrient Tank - PH -5.85, EC -1.0, Temp-19c 27.02.2024 Topping on all girls, 4 cut par plant Detailly clean grow room floor, benches and main room floor, From this week start feeding more, runoff is lower than input Lower humidity to 58-60% Girls looking great so far PAR 380 PPFD, VPD 0.9, RH 58-60%, Temp Night-21c, Day-25c, Leaf temperature 22c, Light distance 75cm, CO2 650+ ppm 360w@75cm distance NT-Nutrient Tank - PH -5.95, EC -0.9, Temp-19c 28.02.2024 Have timer malfunction, watering didn't work for some time, not affected by roots, still wet when realize defect Replace all filters, great condition so far, no need for changing After topping girls looking healthy, PAR 360 PPFD, VPD 0.9, RH 58-60%, Temp Night-21c, Day-25c, Leaf temperature 22c, Light distance 75cm, CO2 650+ ppm 380w@75cm distance NT-Nutrient Tank - PH -6.02, EC -0.84, Temp-19c Nutrient strength still drooping, next top-up will be a higher strength, around 1.1EC 29.02.2024 Check roots, they start to the bottom off the bucket, still nice and white Slowly continue to give more power to light, still have more than 1/3 off Diablo strength PAR 410 PPFD, VPD 0.9, RH 58-60%, Temp Night-21c, Day-25c, Leaf temperature 22c, Light distance 75cm, CO2 650+ ppm Nutrient Tank - PH -6.04, EC -0.81, Temp-20c Ph is stabile so far, i don't adjust anything at this point, lets swing a little bit. If start to going above 6.2 i will bring it down with PH- Humidifier operate less and less, girls make humidity in room 400w@70cm distance 01.03.2024 Again have issue with watering timers (DH48S-S), stop working again, noticed that early so no damage Will need to invest in better timer for misting, this one is start to malfunction😡 Girls growing fast this week, no problem at all😇 Every day their progress can be seen 😀 Like that girls are almost same height and structure, very uniform growth by any mean👏 Replace all filters and clean UV-c bulb PAR 460 PPFD, VPD 0.9, RH 58-60%, Temp Night-21c, Day-25/26c, Leaf temperature 22c, Light distance 70cm, CO2 650+ ppm Nutrient Tank - PH -6.05, EC -0.86, Temp-22c 414w@70com distance 02.03.2021 Girls start to drink noticeable more water and nutrients, EC drop in tanks by 0.2 in last two days, PH is stabile, going on base side by little Replace all filters , set Diablo to 440w without changing light height, let it shine 😀 Start to manipulate branches and tucking big fan leaves, recovery from topping is apparent, two new shoots are larger and larger every day If growth continue with this speed, flowering probably in middle off next week, probably don't want to wait more than that All three girls looking very similar, really great genetic , very uniform growth and structure Hot and humid outside condition, thin this year we hit several HIGH Temp Record! PAR 490 PPFD, VPD 0.9, RH 58-61%, Temp Night-21c, Day-25/26c, Leaf temperature 22c, Light distance 70cm, CO2 650+ ppm Nutrient Tank - PH -6.07, EC -0.80, Temp-22c 03.03.2024 Top up tank with 5l off fresh solution @ 1.2EC Nutrient strength still dropping significantly compared with starting , PH rising slightly. Need to adjust at 6.2 to 5.95 Next nutrient mix will be 2ml AN connoisseur AB @ 1.2EC Replace all filters, little participation on them, mostly from Kelp Remove couple off leaves from all girls, preparing for next week defoliation Forget to refill Humidifier so for couple off hours RH was 48-50%, girls drink more than usual, water and nutrients. Maximum PPFD at center is 600, at edges 440 PPFD PAR 560 PPFD, VPD 0.9, RH 58-61%, Temp Night-21c, Day-25/26c, Leaf temperature 22c, Light distance 70cm, CO2 850+ ppm Nutrient Tank - PH -5.95, EC -0.84, Temp-22c 480w@65cm distance

Started the final week of nutrients. Then ill be switching to flawless finish and pure water the last week. Saskatoon Berry has been a very pleasant growing experience. Csnt wait for them to fatten up this final 20 days.

This week i topped the plant at the 4-5th node Check out YouTube video SuperSmoker for more!

Nothing to really say except that they are growing very well Thank you for reading I will continue to update have a happy grow

I just wanted to let the people know about topping and the benefits and when I did my research there was not much for documentary purposes very great results super cropping is a must and topping to create more nodes

This was the last of them to come up.

Last auto i'll grow , autos are actualy good for fast and not so heavy stoners , my yield is good but not the way i want it , so i'll keep improving my shit , starting with femenised seeds next run also a blueberry , first femenised im going to use , so lets hope it will have a better harvest. Overall this autoflower blueberry yielded the most of all my autoflowers , dense buds , good quality and very fruity smoke!

The babies 😍 have a beautiful look and colors, they seem quite filled with resin. Now the drying phase of 15 days begins after which I will complete the trimming and weigh it. By eye I can say that it will be about 100gr per plant

Week 7 of flowering 4 Purple Push Pops PPP (grew 2023 outside). Clones from my clone guy 1000w LED, 4G Autopots,, coco/perlite 65/35, GH 3-part+ flourolicious, calimagic, SI, chelated iron, and humic acid , RO water, AC pro Controller and T8, 5x5 GG Tent with extension. Garage grow SoCal This week the girls had a hot week in the garage averaging 88°. We started filling out, got more mature, and started showing colors. We’re running just under 1000ppm with no issues. I’m having reservoir funk issues so I’m switching to jacks RO this week. .8g a day. This weeks accomplishments: Split electric load (safety) This week: Switch nutes upgrade reservoir and lines next week. Long term issues It’s hot. Straight 90s this week. So the same - Cooling and VPD targets during heat waves Preventing pest and mold issues during high humidity conditions. I hope you all are having as much fun as I am. Best of luck gromies. Check out my black cherry gelato grow. Just posted my outdoor light dep grow - side by side with my indoor grow- same clone batch. This should be a great comparison of indoor versus outdoor grows side by side 👍

I didn’t yield as much as I would like but I did get some quality flower 83 ofgrams worth between the three cardi b plants, and about 74 grams of 2 envy mintz plants I did have a lot of stress in the beginning which got corrected late and also I might have flipped too early , but all in all it’s some tasty beautiful flower definitely running again gonna do 1 plant this time so tune in for that journal

2 late flowered