After 11 weeks, I harvested the plants in two stages. It went faster than I thought, and the yields are impressive. The yields are much better for the four plants that I was able to keep shorter in height. They developed more dense, firm buds than the taller four plants, which is why I harvested them a few days later. I only watered with water during the last week and lowered the light to 600-700 ppfd. I'm drying now at 20 degrees Celsius and 55-60% relative humidity until the first stems snap, then the herb goes into hygrometer jars for curing. This time I trimmed wet because there were some really thick branches, and I didn't want to risk mold. All in all, it looks like a good harvest. I misjudged the height with this strain. I thought I could keep the plants relatively short by using topping and LST (low-stress training). This only worked for half of them. One of the plants was about 3 cm below the light, which is really suboptimal because I have no space above. I might have chosen a smaller pot size and swapped the plants' positions more often. I was also a bit too cautious with defoliation and pruning, but this was planned as an experiment to grow bushier plants, which didn't make me as happy in my application. Due to the high CO2 content, the cannabis grows exceptionally bushy and leafy. It requires regular pruning. The buds themselves have turned out really well. They are nice and firm, some quite large, and covered with many trichomes. The smell of the strain is less intense than I thought but still very pleasant.