Ok, so it's slowly getting thicker and frostier. At week seven my girl could be ready in anywhere from two weeks to four weeks more. The light was dropped closer to the top of the canopy. I decided to try 15 cm of distance, as well four 50W LEDs are not as powerful as the 600W HID or LED panels that are usually used in grow tents. I will of course keep an eye for signs of light and heat stress, but I suspect that won't be a problem. Update Day 89. Today I decided to turn the plant around to see the back colas and their growth. Then I found some mites under the leaves after examining weird spots in a couple of leaves. It seems to me that there was not enough airflow to deter the mites from making home in the back leaves, when compared to the front leaves of my plant. Lesson learnt, rotate plant often, ensure good and even airflow. I didn't find any webs beside a really small one seen on the video (most affected leaf). So, I think I found them mites early. I only found this kind of damage on very few leaves, and each leave contained less than 8 mites (at least that I could see) and a couple of eggs. So it seems that paying close attention to my leaves saved me from an out of control infestation. Anyhow... I removed all of the leaves that had even a single mite, or a single mark of discoloration. Also, I disinfected the grow tent, top of soil and lower part of the branches by spraying them with a 1/4 tbsp of bleach per liter of water. After that was completely dry, I mixed one part rubbing alcohol with 9 parts water and misted both sides of the leaves and even the buds directly (ethanol evaporates easily, so there shouldn't be residues left after it dries completely). I got these remedies from https://www.growweedeasy.com/cannabis-plant-problems/how-to-get-rid-of-spider-mites I will apply them every 3-4 days and keep a good eye on the leaves. Prevention is key, and some aspects I could've considered before are: 1. not grow any other plant next to my cannabis 2. Don't come into my indoor growtent after tending my outdoor plants. 3. Ensure even and plenty airflow. So, I attacked back strongly. I cut more leaves than those that showed damage, to increase airflow. I will be on the watch for pests and will rotate my plant often, as well as spraying a few times every week, just to make sure they don't come back. I also am going to build a kind of metal wire cage to separate the colas further and make it harder for any pest to spread. Its only my second grow, but from what I've read online about mites, it's way more costly (time and money) to deal with an infestation than to strike them hard early. I guess that specially now that I noticed them before they even made webs. Look closely at your girls growbros ! Update day 90. So this morning I. Becker the trichomes and they seem to have gotten more cloudy. I am not an expert at that, but they are starting to be fewer clear and more milky. I will keep an eye on them, but it think harvest might be here very soon, probably closer to the 9 week mark than to the 12 week one (I'm about to finish the 7th week)...

Can't wait to blazeeee Feeding💪 10/17 Water30L+Cleanse80ml+calmag@190ppm Ph6.3 Ebb 10.42/11.32/12.26/13 Clone 11.35/12.21/13.05/14 Average runoff ec1.5 Keeper 300ml per pot 10/18 Water26L+Flawless90ml+calmag@300ppm Ph6.3 Ebb 11.38/12.24/13.17 Average runoff ec1.2 ph6.5 Clone 12.38/13.56/15.20/16.10 Average runoff ec1.5 ppm750 10/19 Water26L+Cleanse80ml+calmag@200ppm Ph6.3 Ebb 11.12/11.48/12.24 Average runoff ec1.4 Clone 11.50/12.12/12.37/13.37/14.40 Average runoff ec1.3 ph6.6 10/20 Water30L+Cleanse30ml+Calmag@190ppm Ph6.4 Ebb11.42/12.22/13.20/14 Clone 12.40/13.20/14.20/14.45/15.15 Average runoff 1.2ec ph6.4-6.7 10/22 last light day 10/23 2 Pm Cut and hang Plan 21day at 23temp 55rh

For this week, plants are still looking healthy, followed the usual regime of normal water and nutrient feed pattern. I didn't fill the need to defoliate, so I mostly did some leaf tucking. At his stage, the two plants have filled up the box, and they still have room to grow horizontally, so a note to self to flower 2 clones a week early next grow.

~FastBuds Tropicana Cookies~ This was my first time running this FastBuds strain, along with my first attempt at 'hydroponic' growing using the AirCube Active Oxygen Ebb/Flow System from GrowAce. I cultivated three plants from seed to finish in just over 70 days growing in a 70/30 Coco/Perlite mix coupled with a layer of straight Perlite in the bottom of the fabric pots to ensure drainage and fed Plagron nutrients for the entire run with the exception of a 10 day flush at the end. Among those three cultivars, I had three distinctly different phenotypes. The #1 plant grew short and extremely bushy, with beautiful thick purple flowers, showing more Indica like traits. The #2 plant, which was the only one of the three that was topped, stretched her 'legs' and grew fairly tall in comparison to the #1. She also lacked the deep purple coloration of the #1, having just hints of light lavender in her flowers which were stacked tightly and completely frosted over with glistening trichomes! Lastly, the #3 phenotype grew the tallest of the bunch with wide, 'Sativa-like', node spacing. She was the one that experienced several issues during the grow, but finished out not looking too bad with a super dark purple coloration to her flowers that almost appears black. That dark purple color, coupled with her dark orange pistils give her flowers extra eye appeal! FastBuds Tropicana Cookies Auto was a very easy to cultivate strain and produced really spectacular results all things considered. I'll definitely be looking forward to running this one again in a 100% organic grow and can't wait to the results from that! 😎👍 Now let me move on the the AirCube Active Oxygen Ebb/Flow System from GrowAce. I was sponsored this system in return for my feedback on it shared through my Social Media accounts. On paper, this looks like a really great product, and I'm sure with enough time and experience you could get optimal results from using it, but for me that just was not the case. The initial setup went very smoothly, GrowAce's AirCube System looks to be extremely well made, comes with fairly clear instructions, and went together easily. I did add hose clamps to all the fittings attached to hoses for an extra measure of insurance against leaks (no one needs 20+gallons flooding the grow room!) and also placed the reservoir and 'brain bucket' outside of my 4x4 which allowed me to place all six AirCube pots in the tent, and yes it ended up being a bit too tight for me... it probably would work better with 3 plants or less in a 4x4. So lets get in to my pluses and minuses in my opinion for the GrowAce AirCube Active Oxygen Ebb/Flow System: Positives: • Well made • Easy to assemble • Easy to understand instructions and lots of 'how to' media available • Easily expandable Negatives: • Not for novices, previous hydroponic growing experience needed • No way to control solution temperature in reservoir • Roots growing out of the fabric pots end up dying and rotting which results in a ton of debris in the solution necessitating draining/cleaning/refilling the system every 4-5 days • No way to adjust nutrient levels for individual plants, they all get the same PPM like it or not. • Requires having all plants start together, and finish together as there is no way to flush individual plants. • Lastly, I like to turn my plants, which is impossible and also to photograph them which is difficult with this setup. All in all, I enjoyed the experience of 'hydro' growing, but am ready to get back to what I really LOVE to do which is 100% organic grows... Stay tuned fam!

I touched one of the leafs with trichomes on it. Smells VERY citrusy/lemony/fruity. Very excited for this strain! Buds are very solid. It's a hybrid with Durban Poison X Rainmaker (Citral Skunk x Mandarin) x Gorilla Glue #4.

Auf der Waage im getrockneten Zustand waren es 130g somit habe ich mir den Fixkosten ein €/g von 2.55€/g das finde ich nicht schlecht

Deluxe sugar cane was amazing to grow from beginning to end. It’s an easy plant that recovers well. The smell gets strong after 2 weeks of cure. One of the best grows I’ve ever done.

The time is quickly approaching, when these three girls will be harvested and whole-plant dried for like 2 weeks or so. I believe I will be harvesting this coming weekend after I check the maturity of the trichomes. I'm hoping that Big Lemon produces at least 2 LBS of dried flowers.

Drying and curing always the biggest challenge for me due too constant climate change in my area, living near the mountains have its flaws too..🧐 Oh well still love growing..✌️

Now they are in 15 liter felt pots. I did some defoliation to open up the lower branches.

************** 13.03. Day 1 ************** 🤞🏼😎 I have new cuttings. Sour Frootz from Karma Genetics. I planted the cuttings in 0.2 L pots. I only applied fertilizer to the large pot. So Let’s grow again 💚💯 ******************************************* 18.03. Day 6 sprinkled with bactrex and transferred into the large pots *******************************************

Flowering time was literally 44days to include 48hrs of darkness before cutting down. Also showed 0 nute issues. Only regret is I cloned the hell out of her and let her get too tall which killed my yield....so far, but clones are now all bigger than mom wooo hahaha! So in the end I was expecting 1.5 oz and got 1.3 (however, I havent harvested the roughly 4 grams of popcorns yet) which is fine being she made some top shelf buds...they a beauties!

Saturday March 19th GrowUpdate: Here’s my 10x10 grow setup with multiple strains growing. I am testing my 2 new BloomPlusXP4000’s and so far love them!! I have TOPGREENER heavy duty smart plugs with energy monitoring hooked up to both my lights and exhaust fan. I can turn on and off from anywhere on my phone. Govee Wi-Fi Bluetooth hygrometers that send me notifications and I can check the temp and humidity from anywhere on my phone. Globe smart power strip with 4 sockets that can be run individually from my phone.

cookie n cream Clone one from 66Zombie & ATM

Por una parte tenemos la que llamaremos Biscotii 1: Tiene un tamaño monstruoso, que tuve que doblar en varias ocasiones el tallo porque no me daba más el foco para subirlo. De hecho una de las ocasiones me quemo una hoja del puntal y un pelín la puntita y como se puede ver hizo que la punta parezca un monstruo!! enorme, grande y de forma especial. Hay gente en instagram que me pregunta que si lleva anabolizantes jajaajja lo más parecido a eso es los nutrientes de plagron!!! Que las revienta a las pequeñas Esta tiene unos tonos morados que la hacen muy atractiva y una resina generosa. El olor es fuerte y la altura estirada es una pasada!! Por otra parte la Biscotti 2: El tamaño es inferior que la anterior, pero no por eso diría que poco productiva... Tiene un central que da miedo igualmente, los satélites son una pasada llena de resina. En esta ocasión no tiene tonos morados, pero tiene mayor resina. En general ambas dos tapan la botella de litro y medio de agua, prieta, olorosa y con resina para aburrir!! 😍😍😍😍😍 El peso le pondré en seco en cuanto lo pese 😇

Treated for pests again will repeat every three days until last week of flush. Nice pink colour on one but hard to get a good picture. Will take them out next week and take some better quality photos! Some thirsty girls budding up nicely hopefully get a good harvest!

I'll do final height and all that after it's done.. One is really tall and the other one is short and Bushy. Chopped the shorter Bushy La Diva 6-20-2020 down today 😁💚

Last week flush for second week and than 2-3days of dark cut, hang up,and rest for week