6/21/22-Presoak 24hrs 6/22/22-Damp Paper towel 24hrs 6/23/22-Popped and placed into medium.. watered with 2oz+- water 6/25/22-Germination!!

Partway through last week I noticed that there was no runoff after feedings. I increased the time the fertigation pump runs to 2 mins twice a day. It seems like either the root system is drinking up more or the added aeration has changed how much runoff comes out. Plant 1 has fallen behind in growth. The inter-nodal spacing was so tight that the new growth was being strangled by the older fan leaves and other growth. I adjusted the LST to help and pruned a very small amount of leaves. It seems to be doing better, but is several inches shorter than Zkittlez 2 which has had some really explosive growth. I started the scrog today, bending many of Zkittlez 2’s branches down to fill out the tent. I bent a few branches on Zkittlez 1, but it’s still a little short. This week I upped the nutrients, almost doubling the Cocos A & B, Multizen and Cal Mag. I still tried to keep EC down though, only allowing it to rise by about 300mS/cm. This could actually be the first week of flower, but think I’ve started to spot some pistils, but I’m not sure. I can’t find the breeder’s info, but think it’s supposed to have a 4 week veg time and 10 week flowering period. Update: lots of pistils being thrown out especially from Zkittlez 2. It’s definitely the first week of flower. There has been a lot of growth since the start of the week. I continued to bend branches down and tuck them under the net, but now that buds are really starting to take shape I'm going to lay of any further stressing. I noticed that there was little runoff over the past couple days. Yesterday (Monday) I had to refill the reservoir and mix up new nutrients because there was only an inch of water left. These girls have gotten a lot thirstier over the past 2 weeks. I've upped the feeding times to 3 minutes twice a day.

So #3 and #4 were selected by me to go into the flower tent(video) and the other 2 are going to veg longer and get 5 gal airpots for their turn in approx 4 weeks, as soon as my autos are done and 3+4 are halfway done.

Noticing some buds. Growing a Tad in size. Thinking of getting a new light as this is useless. Hardly impacts half the plant.

🍬⛽️

Creo que en dos semanitas mas están, estoy dudando de si llego a los 400g en producción final, espero que si, pero veremos, tuve problemas de PH alto por no saber que regaba con agua con PH de 9, y ahora ya estoy rebajando con vinagre blanco, usando 3,75 ml por litro de agua...

11/10/21 new week for Captain future Single photos will be updated soon She bit slower then the rest but getting there topping has bin done and everything going great so far plants loving the new FC-4800 so as i 🤩 absolutely no extra heat is coming of them 👌🏻 I maybe will top some more but as far it Goes for LST this will be the only thing i will do to the plants let the rest grow freely visit www.marshydro.eu for your best gear and use the PROMO CODE: DEVILSBUD Fully marshydro supported Setup: Marshydro GT120x120x200 Marshydro FC-4800 LED lamp Mars Hydro tent handy info ●【Lock All Light Insid】MARS HYDRO Grow Tent Interior is made of diamond mylar. Non-toxic to the environment, no harm to plants. High-quality 1680D canvas being double stitched, (ALL OTHERS BRAND grow tent is 601D canvas) which is tear-proof for perfect light locking, No light leaks or rips at all. ●【Durability Grow Tent】Stable Metal corner adapters and poles are the trustful supporters of the tent. No rusting nor paint-falling. Quick easy tool-free installation. Carries strong heavy-duty SBS zippers, double layer lining to create a light-proof seal. ●【Easy Observation of your Plants】Special peeks window made by double layers of cloths. Observe the growing conditions of your plants without opening the tent and avoid disturbing plants. The peek window also serves to dissipate heat and ventilate air. ●【Removable Tray Keep Clean】The package includes a removable waterproof floor tray to hold soil and fallen leaves. The tray can be taken out easily to wash. Removable and water-proof makes cleaning easy. ●【Good Ventilation&Fast Assembly】 Circular double-sleeved vent holes with adjustable nylon strap for air circulation by exhaust fan, ducting, carbon filter, or reflector. Better allows proper light, heat, and airflow. Quick tool-free installation. Reinforced by a sturdy metal frame to ensure security and stability, supports up to 140lb. Perfectly safeguard your plants to thrive even in winter. Some info about the Marshydro FC-4800 Superb Quality LED Chips: The whole light is composed of 1206 pcs Samsung lm301b and Osram 660nm chips. More than two times as many LEDs are used to drive the grow lights at low currents and to avoid overdrive. Quality is guaranteed and efficiency is up to 2.8 μmol/j. Even PAR Distribution and High PPFD Output: The multi-light bar design and the densely distributed light chips enable the LED grow lights to achieve the optimum PPFD required for plant growth over the entire effective coverage area. Specifically Designed Spectrum: To ensure even plant growth, blue and red light are enhanced on the basis of a full spectrum combination. Not only does this accelerate plant growth, but it also improves the yield and quality of the plants at the same time. Dimming Daisy Chain Function: The dimming function saves on electricity costs and enables brightness from 10% to 100% for the different stages of plant growth. A single master light can connect up to 30 lights in a daisy-chain system. Business LED Grow Light: The light's wavy heat sink dissipates heat quickly and the IP65 waterproof allows the light to operate in humid conditions. 180° collapsible feature for easier installation. All these features provide favorable assistance for commercial cultivation.

The first week of flowering went well, no defects or anything. I put up a second trellis with small compartments. And a dehumidifier to keep the humidity between 50% and 60% I have also started the flowering nutrition , including the New 'powerbuds' from plagron. Does anyone happen to have any experience with that? Now it is waiting for the plant to stop stretching. Around day 20 I will defoliate the plants one more time

Alright here we go, let the flowering begin. Still have just been giving her water straight from the hose. This week I will get the top netting in place.

Ok, so it's slowly getting thicker and frostier. At week seven my girl could be ready in anywhere from two weeks to four weeks more. The light was dropped closer to the top of the canopy. I decided to try 15 cm of distance, as well four 50W LEDs are not as powerful as the 600W HID or LED panels that are usually used in grow tents. I will of course keep an eye for signs of light and heat stress, but I suspect that won't be a problem. Update Day 89. Today I decided to turn the plant around to see the back colas and their growth. Then I found some mites under the leaves after examining weird spots in a couple of leaves. It seems to me that there was not enough airflow to deter the mites from making home in the back leaves, when compared to the front leaves of my plant. Lesson learnt, rotate plant often, ensure good and even airflow. I didn't find any webs beside a really small one seen on the video (most affected leaf). So, I think I found them mites early. I only found this kind of damage on very few leaves, and each leave contained less than 8 mites (at least that I could see) and a couple of eggs. So it seems that paying close attention to my leaves saved me from an out of control infestation. Anyhow... I removed all of the leaves that had even a single mite, or a single mark of discoloration. Also, I disinfected the grow tent, top of soil and lower part of the branches by spraying them with a 1/4 tbsp of bleach per liter of water. After that was completely dry, I mixed one part rubbing alcohol with 9 parts water and misted both sides of the leaves and even the buds directly (ethanol evaporates easily, so there shouldn't be residues left after it dries completely). I got these remedies from https://www.growweedeasy.com/cannabis-plant-problems/how-to-get-rid-of-spider-mites I will apply them every 3-4 days and keep a good eye on the leaves. Prevention is key, and some aspects I could've considered before are: 1. not grow any other plant next to my cannabis 2. Don't come into my indoor growtent after tending my outdoor plants. 3. Ensure even and plenty airflow. So, I attacked back strongly. I cut more leaves than those that showed damage, to increase airflow. I will be on the watch for pests and will rotate my plant often, as well as spraying a few times every week, just to make sure they don't come back. I also am going to build a kind of metal wire cage to separate the colas further and make it harder for any pest to spread. Its only my second grow, but from what I've read online about mites, it's way more costly (time and money) to deal with an infestation than to strike them hard early. I guess that specially now that I noticed them before they even made webs. Look closely at your girls growbros ! Update day 90. So this morning I. Becker the trichomes and they seem to have gotten more cloudy. I am not an expert at that, but they are starting to be fewer clear and more milky. I will keep an eye on them, but it think harvest might be here very soon, probably closer to the 9 week mark than to the 12 week one (I'm about to finish the 7th week)...

————————————————————— WEEK 9 / DAY 58-64 Mars Hydro FC-E3000 Floragard Professional GrowMix 11L Plant bag made of fleece Light: 40cm Schedule: 18/6; PPFD: 1050-1150umol/m2/s 19° C - 45 RH 1L per Plant PH 6,5-7 4ml BioGrow; 4ml TopMax ; 4ml BioBloom 1ml CalMag #1 Royal Critical Automatic #2 Royal Critical Automatic Fan, extractor and pump ON 24/0. ————————————————————— -17.03.2025 The fourth week of flowering begins. Everything is going great, so far there have been no complications. From this week onwards, the quantity of BioGrow, BioBloom and TopMax is increased to 4ml/1L. The lamp is also turned up, the measured value with the PhotoneApp is 1050-1150. -19.03.2025 Both plants were watered with 1.5 liters of water with fertilizer each. In addition, an extra fan is now running for better air circulation. -23.03.2025 The next week is coming to an end. The plants look good, the buds are growing and getting nice and frosty. I think the week after next will be the time to harvest the ladies. Both plants were watered the last time with 1.5 liters of water and fertilizer mix. From next week only clear water.

Hi everyone 🤗. It was rinsed slightly 3 days ago and now only gets water with 0.4 EC. From tomorrow on she won't get any Canna Boost anymore, because I'm not the fan of giving it to the end :-) It always looks more beautiful and more beautiful 😍. You can see how she removes the last nutrients from the leaves and slowly comes to an end 😇. From next week the trichome pictures will also be added 👍. I can't wait to try them 🤣 I wish you all a nice week, stay healthy 🙏🏻 and let it grow 🌱 You can buy this Strain at : https://sweetseeds.es/ Sweet Seeds Cup 🏆 Type: San Fernando Lemon Kush ☝️🏼 Genetics: OG Kush x Kosher Kush 👍 Vega lamp: 2 x Todogrow Led Quantum Board 100 W 💡 Bloom Lamp : 2 x Todogrow Led Cxb 3590 COB 3500 K 205W 💡💡☝️🏼 Earth: Canna Bio ☝️🏼 Fertilizer: Canna Bio ☝️🏼🌱 Water: Osmosis water mixed with normal water (24 hours stale that the chlorine evaporates) to 0.2 EC. Add Cal / Mag to 0.4 Ec Ph with Organic Ph - to 6.0 - 6.3 💦💧

She’s struggling to bloom due to being sat too low under the lights but she’s still going unfortunately not much flower but still growing with the bracts swelling up the pistols. She will receive just phd water as req

📆 Semana 3: Esta variedad sera un cultivo mixto, interior y exterior para ver todo su poderio em ambos lugares. Ha sido una buena semana en la que han dado un gran cambio en sus lugares definitivo 😎. Se le ha aplicado un tratamiento insecticida con agua + tierra de diatomeas ( 1 cucharadita por litro de agua), también se le aplica un tratamiento fungicida con una infusión de cola de caballo para evitar futuro moho. A partir de ahora se aplica riego por goteo, 1/3 de la dosis recomendada por el fabricante ya que al estar en exterior y en buena tierra tiene bastante comida. En interior seguira el mismo plan nutricional que el resto, ajustando sus dosis de nutrientes segun sean requeridos. Potencia de la lámpara: 60% , se conecta el Marshydro TS-1000 para dar apoyo en la carpa de 1.50 x 1.50 x 1.50