She reeks ooh my God if you haven't grown this strain you gotta she smells horrible rotten fruit jet fuel sweet she looks wonderfull All she is getting is water from here on out Gallons on gallons start the Flushing 11/26/23

Grapes n Cream fast flowering photo from Atlas seeds comming in on her first week of veg from seedling stage she popped up first out of the plants an shot straight up Comming to the end of week 1 of veg the Grapes an Cream is growing good starting to pick up speed

A lot more happening this week! As shown in the pics, and as suspected, I have a manganese deficiency. I've been keeping my pH level at 6.2 in coco, manganese is taken up best by the plant below 6.0 pH. Dropping my ph level to 5.8 pH, and flushing with lower pH, hopefully it will solve the issue over the course of a few days. I made a new frame for a SCROG, with a "custom bend" in the CPVC pipe on both ends. The bend will allow me to take advantage of the slack material in the sides of my 4x4 tent. I'd previously taken 4" out of all the upright poles to shorten the tent so it would fit in the room due to low ceilings, meaning I had extra slack in my tent walls. The bend in the net frame pushes the sides of the tent out to 5 foot wide. My first SCROG net was a 6" mesh from Amazon, immediately knew I wanted a smaller mesh. Next time around I built my own with a 4" mesh and used the 4" for several grows. This time I decided to go with an even smaller, 3" mesh, and already I like it better. I don't really see myself going much smaller than 3" mesh though. It seems to work well, and any smaller and it may be too tight trying to work the plant through the opening sometimes, which if not careful, will damage the plant. I usually use a & gal cloth pot, grow off rules stated we 0had to use a 5 gal pot. Seeing as I only had 7 gal on hand, I was stuck picking up a Root Farm 5 gal cloth pot locally, as you can see, the roots didn't really stay contained, nor did they "air prune", i had to tear them off before installing the net above. On the last day of week 6 I finally got my net installed, and the plant SCROGged. I should have put the net in place a week or two earlier, it would have been easier to manipulate the plant, however the plant will still have a week to recover. I tie the net in place above the plant, and slowly lower it down, as I bend and super crop the main stalk over parallel to the net, and work all the branches underneath and spread them out. As the plant grows I'll continue to push branches back down through the net and moving them out to the next hole. This will greatly increase yields by allowing light to more bud sites, keeping all buds the same height and thus the same distance from the light. small budsites on a vertical branch, will transform into their own cola once the branch is laid on its side. Instead of a Christmas tree type of plant, with one large main cola, and smaller and smaller buds as you move further down the plant, you end up with a bunch of colas that are all close to the same size, and more importantly, the same level of maturity. The SCROG method, combined with super cropping, and defoliation has greatly increased my yields. As the plant is getting worked into the net, I'll defoliate where necessary, ie a huge fan leaf covering bud sites, however for the next several weeks I'll be defoliating so mush every night or two, systematically trimming off all fan leaves, and stripping everything below the net, and any small bud sites that wont produce well. Usually by the time I'm half way through the flower stage there are no big fan leaves left to be found. It helps with light penetration, which results in a higher quality, higher quantity yield, as well as airflow, which will help prevent White Powdery Mildew and other molds etc. Once a fan leaf is 14 days old, its ability to photosynthesize light, starts to degrade. Once it reaches a certain point, the leaf drains more energy from the plant, than it's giving the plant. My best yields have been from heavily defoliated plants, my last grow I couldn't physically defoliate quite as heavily as usual, and I ended up about 25-30% less bud than expected

Looks like this might be the last week for this girl. Was hoping to see more change in tricomes but not sure if worth the wait. Give it a few more days and see what the loop says.

Day 1 of week 2.. really dont know how this plant is doing as I'm new to autos and DWC however , seems to to be growing.... Please , if anyone sees something that could be a diagnosis of a problem then then please let let me let me know guys , thick skinned haha... Week 2 Day 6: plants starting to fill out nicely now , one root has grown roughly 2" in length in the past 24 hours and there are now numerous roots poking through through the net pot dangling in the res :)

Absolutely blown away by the new 2025 setup, prev ran 3 tents 😂, switched to AC Ifinity 2,4 x 1,2 single tent, 3 x 150 or 6“ fans. Fans all port outside, 2 exhaust with yet uncoupled carbon filters, 1 inlet with pollen filter. 6-7 air push fans (not all yet on 😂). SpiderFarmer 16L humidifier, inkbird RH control, inkbird heat control, heater, trotek dehumidifier (12L) with drain line and reservoir. Blumat system with RO fed 20L water butt, each pot with 3 long ceramic blumats. Data logger from SensorPush including WiFi hub and 4 sensors. One in cellar room (lung room), one above each plant canopy. Setup logger n sensors and track VPD. System running itself

BIG UPDATE THIS WEEK !!! ---------------------------------- FEEDING MISTAKE / TRANSPLANTING THE PLANT ------------------------------------------------------- Last week, the plant was showing some feeding issue (some burned tips). After discussing with another grower ( @Asnoriu ) and carefully listening his advices, I decided to transplant the queen to a bigger pot. 16L can be ok, but I had a long veg (10 weeks), and this was getting too small for the lady. So starting from now, I will always transplant before flowering, since I understood & learned how it help the plant to develop good roots network. The plant probably suffered from too much feeding with Fish-mix. Asnoriu told me He was using it at 50% of the recommend dose, and not at each watering. This totally make sense, especially when i look back at my first grow : I used no fish-mix during almost all the veg, and she grow verry well. My gardening soil was probably rich enough for my plants! I transplanted the plant to a bigger pot (16L -> 30L) and filled the new pot with Biobizz All-Mix soil. I took the plant from the old fabric pot like if it was a sock : what a niiiice and easy technic ! (Thanks again Asnoriu). Watered with pure water (ph at 6.2-6.5), without any nutrients (All-mix is already rich enough). I will feed again in 1-2 weeks. BIG ERROR WHEN APPLYING LST BACK IN THE NEW POT --------------------------------------------------------------- I had to remove my strings (LST) to switch to the new Pot. When I was applying the LST again in the new pot, I went too far with tension... And the main-lining broke 😟 So I fixed it verrry quickly by releasing LST tension, and using a string to tight the stem where it broke. In less than 5 minutes it was fixed. I was verry worried that it may have killed my queen.... But she didn't shown any sign of stunt, and 48h hours later, I can say that she look verry good. This doesn't slowed her. She seems to grow faster since transplant, so all good :) So, note to myself : never try to LST when flowering started, or only verry carefully, with just littles adjustements. SPONSORSHIP ANNOUNCEMENT & LIGHT + TENT UPGRADE -------------------------------------------------------------------- I'm verry proud to announce that Mars Hydro ( @MarsHydroLED ) decided to sponsor me :) So I received a TSW2000 (basically 2X the output of a TS1000), and a Mars Hydro tent (100cm x 100cm x 180cm) That's PER-FECT, since I was already using a TS1000, which I bought because it was the best deal (price/quality) for me. I'm verrrrry happy about it, and I feel verry lucky to be selected by Mars Hydro 🙌 This mean a lot to me. I still have a lot to learn, but I'm doing my best to improve myself and learn. Learning from the other, and sharing my experience, and being rewarded for that... Damn, so cool 😍 MENTION ----------- Once again, thanks a lot @Asnoriu You are MY grower of the month, for sharing your ideas, opinions, and advices with me :) WEEK DETAILS ---------------- - Day 79 : Watering 1L (ph 6.2 - 6.5) with feeding (as detailed in the week details) - Day 82 : Transplanting from 16L pot to 30L pot. Broke stem, and repared it. Upgraded from Mars Hydro TS1000 to TSW2000 (2x more powerfull). Watered with pure water. - Day 84 : Plant look verry great, and seems to stretch & flower faster :)

Y es el turno de las resionosisimas Lebron Haze. Hermosas plantas, ya te siento cerca tu colocón!

My first grow has turned in to a science project. Switched from AN pH perfect Grow/Micro/Bloom to AN pH Connesseur, still giving 50% dose. Had rain Monday maybe, didn't water for 3 days, hit her up last night with the Connesseur and just a tad of Big Bud, looks really good this morning. Yesterday I had mini buds with white pistils, that's why the Big Bud. Everything else is normal- watering 32 oz of water/nutrients at night, MAYBE mist the top soil but haven't really needed it. Will most likely switch to AN Connesseur bloom next week. Very satisfied with Fast Buds and Advanced Nutrients products. It is all on the grower!

Welcome back! On day 21, since she was growing fast, I decided to top her. I was a bit afraid of doing so with an autoflower, but then I saw @Eurus CBD Crack diary and that actually convinced me. Well, she didn’t even notice the top, and kept growing like crazy, yay! This week I’ll give her 0.25ml/L more of Connoisseur A+B, as well as the usual 0.5ml/L of Voodoo Juice and B-52. Day 25 (20 from sprout): LST on 6 branches + 4 bigger leaves.

Week 4 ( 22/8/23 - 28/8/23)

she grows healthy ... with substrate top of mills ... she has a height of 60 cm ... the diqs are cloudy and under the temperature ... let's hope as we go with it ...

Really looking forward to flipping these ladies next week

Al corte ✂️✂️✂️

Fase final, somente agua. Quase bom

Quick update. Everything is going pretty well, it's growing quickly. 😉✌️

First week setting up my DWC! Assembled the reservoir and cloner/seedling starter and figured out temperature control while waiting on the seeds to be delivered. June 8th, PM: Started germinating the seeds. Germinated in paper towel for 3 days. June 12, afternoon: Transplanted seedlings to the cloner to start seedling growth June: 16, morning: Transplanted to their final reservoir. June 16th (end of Week 1) is really the start of the grow, as it's when the seedlings finally made it into their res. This week was more a "Week 0".

Se va terminando el mes de Marzo y ya se cosecharon las Double Cookies, con un riquisimo aroma pero por sobretodas las cosas con una resina muy pagajosa y abundante. Ya se van al secadero Las lebrones las mantenemos un poquito mas pero tambien estan explotadas. Tumbadas por el peso de los propios cogollos.